IF-MIB::ifHCInOctets.11 = No Such Instance currently exists at this OID
SNMPWALK FOR WINDOWS SERIAL
NAS#sh snmp mib ifmib ifindex serial 0/1/0:30 Interface = GigabitEthernet0/1, Ifindex = 3 Interface IP-Address OK? Method Status Protocol NAS(config)#snmp-server community test RW Configuration on the routerĪ sample of the configuration on Cisco 1941 router on which we poll ifHCInOctets / ifHCOutOctets on the serial interface of VWIC2-1MFT-T1/E1 card: Note: Use the Command Lookup Tool ( registered customers only) in order to obtain more information on the commands used in this section.
This document helps a technician to understand why SNMP walk to poll Serial Interface Utilization using ifHCInOctets and ifHCOutOctets does not work and what is the workaround in such situations. If your network is live, make sure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. However, this document is not restricted to specific software and hardware versions. This document is created using a Cisco 1941 router with VWIC2-1MFT-T1/E1. Correct read-write SNMP community configured on the router.Server from where you are polling the router is reachable.Prerequisites RequirementsĬisco recommends that you meet these requirements before you attempt this configuration:
SNMPWALK FOR WINDOWS HOW TO
This document describes how to perform Simple Network Management Protocol (SNMP) Walk for Serial Interface Utilization on Cisco Routers.
0 kommentar(er)
